Active Subwoofers
Showing all 10 results
-
-
Active Subwoofers
Kenwood KSC-PSW8
Kenwood KSC-PSW8
Key Features
250W peak power
Powered subwoofer
20cm woofer
Aluminum Die-cast frame
Noise-less sound
Wired remote (Level/Freq./phase control)
Line(RCA) + speaker level input
Signal sensing power control(0 reviews)£199.99 Add to basket -
Active Subwoofers
Audison APBMW S8-4
*£229.99 each
APBMW S8-4
SUBWOOFER FOR BMW-MINI
Subwoofers have been designed with electro-acoustic parameters that maximize performance for the factory box available below the seats. The ABS plastic basket, reinforced with fibreglass, and the acoustic structure featuring a front magnet, provide for a minimal installation depth for a perfect compatibility with the whole range. Two 5 mm polyurethane gaskets, supplied, allowing the subwoofer to fit perfectly into the box, decoupling it from vibration.
The 200 mm (8″) APBMW S subwoofers allow a “direct replacement” of the OEM speakers underneath the front seats, making the most of the factory acoustic load and generating deep and crisp low frequencies. You can choose between S8-2 with 2-ohm impedance and S8-4 with 4-ohm impedance for improved system composition versatility. In fact, in the mid-high passive filtered system configuration, with the crossover provided, 4 of the 8-channels of the AP 8.9 bit can be configured in bridge mode delivering 130W RMS to each S8-4 installed under the seat. The S8-2 can be used in a fully active, multi-amplified front system, maximizing the power of the AP 8.9 bit at 2 ohms, and employing additional 2 channels for the rear system. The Neodymium magnet used on S8-4 and S8-2 allows for greater power and control than ferrite while maintaining the depth of installation unaltered.
(0 reviews)£239.99 Add to basket -
-
Active Subwoofers
ETON UG USB 8
ETON UG USB 8
Short of space but need more bass? The USB 8 could be just what you are looking for. This rugged flat box will fit easily under many car seats. An 8″, dual voice coil driver takes care of air movement while the in-built 2 X 50 Watt RMS on board amplifier provides controlled performance down to the deepest reaches of the audio spectrum. Line or speaker inputs are available.
Technical Specification
Maximum Output Power: 160 W (80 W x 2)
Impedance: 2+2 Ohm
Low pass filter: 30 Hz
High Level in for OEM radios
Maximum current: 12 A
Remote control (cable)
Compact aluminium cabinet(0 reviews)£299.99 Add to basket -
Active Subwoofers
Hertz Dieci DBA 200.3
The DBA 200.3 car audio subwoofer box is an active subwoofer system with a 200 mm (8 in.) subwoofer and two passive radiators of the same size, powered by a 140 W amplifier built-in to the back of the enclosure. A control panel is used to adjust frequency, level and acoustic phase according to one’s own listening tastes. The system was designed to satisfy those who love the most demanding low frequency in a compact size, for use in any vehicle.
Data table
Speaker size mm (in.) 200 (8) Power Handling – Peak W 140 Impedance Ω 4 Frequency response Hz 32 ÷ 400 Sensitivity dB SPL 92 (0 reviews)£329.00 Add to basket -
Active Subwoofers
ETON UG USB 10
ETON UG USB 10
The USB 10″ is an active flat box subwoofer for mounting under seat and other suitable positions. A dual voice coil 10″ driver moves plenty of air and is controlled by a 2 X 85.5 Watt RMS amplifier built into the same cabinet. Rugged construction with both high and low level inputs makes this bass producer the perfect product for automotive use and an impressive low-end performer.
Technical Specification
Maximum Output Power: 160 W (80 W x 2)
Impedance: 2+2 Ohm
Low pass filter: 30 Hz
High Level in for OEM radios
Maximum current: 12 A
Remote control (cable)
Compact aluminium cabinet(0 reviews)£364.99 Add to basket -
Active Subwoofers
Audison Prima APBX 8 AS
Audison Prima APBX 8 AS
A super efficient 8″ active subwoofer, the APBX 8 AS delivers incredible bass from a compact enclosure. Rewriting the rules on impedance matching and power supply-demand this musical sub bass offering is capable of astonishing performance from relatively low current draw. The enclosure can be mounted face up or face down depending on the kind of bass required and with the included bass level control you can have as much bass as you like at any time.
Technical Specification
Subwoofer size mm (in.): 200 (8)
Subwoofer Voice coil Ø mm (in.): 40 (1.57)
Output power (RMS): 250 W Continuous Power 500 W Peak Power
Impedance ohms: 0.4
Sub box size mm (in.): 386 (15.2) x 158 (6.22) x 298 (11.73)
Magnet: High density flux ferrite
Cone: Water-repellent pressed paper
Weight of one component kg (lb): 6.3 (13.89)(0 reviews)£469.99 Add to basket -
Active Subwoofers
Alpine PWD X5 Subwoofer with 4.1 Channel DSP
4.1 Channel Digital Sound Processor (DSP) with Powered Subwoofer – Alpine PWD-X5
Achieving a perfectly integrated, high-performance car audio installation with only one device is now possible with the new Alpine PWD-X5.
This very unique sound system upgrade product includes a high-performance Digital Sound Processor (DSP), 4-channel amplifier for your front and rear door speakers, as well as an ultra-flat active subwoofer. The small footprint allows the PWD-X5 to be easily installed inside the car’s cabin to enjoy a nice bass upgrade. Connect either OEM radios via high-power speaker level inputs or aftermarket radio via RCA inputs, and control the system through the wired remote control and the convenient smartphone app.
This product is perfect for customers that look for a big improvement of their car’s sound quality, without installing many different devices and routing cables all across their car. The PWD-X5 comes with a full wiring kit including high-quality power cables (4.5 meters) with main fuse.
(0 reviews)£499.95 Read more -
Active Subwoofers
Audison Prima APBX 10 AS
Audison Prima APBX 10 AS
At the forefront of subwoofer technology, Audison take lows to new heights with this active subwoofer. Capitalising on a class D amplifier’s ability to drive extremely low impedance loads, the woofer itself utilises two low impedance voice coils offering an overall nominal impedance of 0.16 Ohms. This means the 400 Watt onboard amplifier can work with extreme efficiency offering mind-blowing bass for such a compact sub/amp combination. With both high and low-level signal inputs, the amplifier offers a built-in Butterworth lo-pass filter (12dB/octave) that can be bypassed when fed via a bit DSP. The APBX 10 AS is equipped with a quick release smart plug for easy removal if extra space is required!
(0 reviews)£529.99 Add to basket