Audison Prima AP 5
The Audison AP 4 midbass offers very extended frequency response, both in high and low frequencies, combined with high efficiency and features a 25 mm pure copper voice coil to ensure more balance in mid-high frequency ranges.
Audison AP 4 is Featuring a 32 mm pure copper mobile voice coil, for high power handling and outstanding low frequency control this Prima 5″ has a treated water-repellent paper cone, featuring a profile developed with FEM (Finite Element Method) simulation technology and optimised using Klippel R&D Scan Vibrometer technology.
|100 mm (4″)
|40 W Continuous Power
120 W Peak Power
|80 ÷ 7,5k Hz
|High density flux ferrite
|Water-repellent pressed paper
- CAR AUDIO
Audison Prima AP4 D
.Add this 4-channel Prima amplifier to a 4.9 bit or 5.9 but amplifier. When integrating with factory fitted multi-speaker systems this add on is a must for expanding the capabilities of Prim bit amplifiers. Sharing the same footprint, up to three Prima amplifiers can be stacked for maximum space efficiency without over heating.
Load Imp. 4 Channels 2 Channels (bridge) 4 Ohm 70 W x 4 260 W x 2 2 Ohm 130 W x 4Rated 0 out of 5(0 reviews)£349.99 Read more
- CAR AUDIO
ETON UG USB 8
ETON UG USB 8
Short of space but need more bass? The USB 8 could be just what you are looking for. This rugged flat box will fit easily under many car seats. An 8″, dual voice coil driver takes care of air movement while the in-built 2 X 50 Watt RMS on board amplifier provides controlled performance down to the deepest reaches of the audio spectrum. Line or speaker inputs are available.
Technical SpecificationMaximum Output Power: 160 W (80 W x 2)
Impedance: 2+2 Ohm
Low pass filter: 30 Hz
High Level in for OEM radios
Maximum current: 12 A
Remote control (cable)
Compact aluminium cabinetRated 0 out of 5(0 reviews)£299.99 Add to basket
- CAR AUDIO
Audison APBMW S8-2
SUBWOOFER FOR BMW-MINI
Subwoofers have been designed with electro-acoustic parameters that maximize performance for the factory box available below the seats. The ABS plastic basket, reinforced with fibreglass, and the acoustic structure featuring a front magnet, provide for a minimal installation depth for a perfect compatibility with the whole range. Two 5 mm polyurethane gaskets, supplied, allowing the subwoofer to fit perfectly into the box, decoupling it from vibration.
The 200 mm (8″) APBMW S subwoofers allow a “direct replacement” of the OEM speakers underneath the front seats, making the most of the factory acoustic load and generating deep and crisp low frequencies. You can choose between S8-2 with 2-ohm impedance and S8-4 with 4-ohm impedance for improved system composition versatility. In fact, in the mid-high passive filtered system configuration, with the crossover provided, 4 of the 8-channels of the AP 8.9 bit can be configured in bridge mode delivering 130W RMS to each S8-4 installed under the seat. The S8-2 can be used in a fully active, multi-amplified front system, maximizing the power of the AP 8.9 bit at 2 ohms, and employing additional 2 channels for the rear system. The Neodymium magnet used on S8-4 and S8-2 allows for greater power and control than ferrite while maintaining the depth of installation unaltered.Rated 0 out of 5(0 reviews)£239.99 Add to basket
- CAR AUDIO
Audison BIT ONE
Audison Bit One is a revolutionary technology processor making the acoustic domain in any car audio system into one outstanding audio build in your vehicle.
Audison Bit One is a multi-function digital processor capable of interfacing with any analog and/or digital source, turning any ordinary system into one with very high-level performance sound system.
Despite its compact size, the bit One is equipped with a powerful, latest generation 266 MHz / 32 bit floating point DSP microprocessor, working in real time on all the functions of the most complete systems.
Managed and configured by a simple and intuitive computer software, it is possible to make adjustments to improve the signal through each phase of its path; from input to output.
DRC – Digital Remote Control (included)
The DRC is the digital interface between the bit one processor and the user. The DRC mounted in the vehicle dashboard, provides access to control of the inputs and volume adjustments, balance, fader and subwoofer volume. Providing source selection between main, aux and optical inputs, it also provides four of the configurations created and saved by the bit one right at hand. The DRC also controls the functions of the Audison Thesis amplifiers when these are installed in the same system.
Optional Accessories ( not included )
DRC Cable Extension kit for installations on especially long vehicles. Total length of the supplied cable with the extension is equal to 6,5 m / 225,90″.
OP 1.5 • TOSLINK Optical Cable
Optical cable ending with TOSLINK connectors for S/PDIF digital audio signals. Cable length: 1,5 m / 59,05″.
OP 4.5 • TOSLINK Optical Cable
Optical cable ending with TOSLINK connectors for S/PDIF digital audio signals. Cable length: 4,5 m/177,16″
STA • F/F Socket TOSLINK adapter
Optical adapter to extend optical cables featuring TOSLINK connectors.
SPM4 – 4 Ch Stereo Passive Mixer
Recommended to extend the number of inputs of bit One processor because they feature a De-equalizer (De-Eq). In that case, any possible non-linear acoustic emissions due to the mixing of the pre-existing filtered channels are duly compensated.Rated 0 out of 5(0 reviews)£549.99 Add to basket